Le Marquis de Sade

Forum du site sur le Marquis de Sade : http://www.sade-ecrivain.com

Vous n'êtes pas identifié.

#1 09-01-2019 08:00:39

Date d'inscription: 23-10-2018
Messages: 57

Selection of grinding wheel in stone grinding

Grinding is a method of cutting a workpiece with a grinding wheel as a cutting tool on a grinding machine. The characteristics of this method are:
(1) Since the grinding wheel itself has high hardness and heat resistance, the grinding can process materials with high hardness, such as hardened steel and hard alloy.
(2) The characteristics of the fiber cutting disc Chinese supplier and the grinding machine determine that the grinding process system can make uniform micro-cutting, generally ap=0.001~0.005mm; the grinding speed is very high, generally up to v=30~50m/s; the grinding machine has good rigidity; Hydraulic drive, so grinding can economically achieve high machining accuracy (it6 ~ it5) and small surface roughness (ra = 0.8 ~ 0.2μm). Grinding is one of the main methods of finishing parts.
(3) The temperature in the grinding zone is high due to severe friction. This can cause stress and deformation of the workpiece and even burn the surface of the workpiece. Therefore, a large amount of coolant must be injected during grinding to reduce the grinding temperature. The coolant can also act as chipping and lubrication.
(4) The radial force during grinding is large. This causes the elastic retraction of the machine tool-grinding wheel-workpiece system so that the actual depth of cut is less than the nominal depth of cut. Therefore, when the grinding is about to be completed, the knife should not be used for light grinding to eliminate the error.
(5) After the abrasive grain is blunt, the hot sale cutting wheel also increases, causing the abrasive grain to break or fall off, and the sharp edge is re-exposed. This characteristic is called “self-sharpness”. Self-sharpening enables grinding to work normally in a certain period of time, but after a certain working time, manual finishing should be carried out to avoid vibration, noise and damage to the surface quality of the workpiece.

Hors ligne

#2 10-01-2019 08:22:26

Mike Watson

Re: Selection of grinding wheel in stone grinding

The grinding method is more efficient now. - Steven C Wyer

Pied de page des forums

Créez Votre Propre Forum
Insérer vos Graphiques
Dictionnaires de Traduction
Hébergé par ForumCrea.com