Le Marquis de Sade

Forum du site sur le Marquis de Sade : http://www.sade-ecrivain.com

Vous n'êtes pas identifié.

#1 13-03-2018 02:23:03

Date d'inscription: 21-11-2016
Messages: 38

Preheating and removal floor

Preheating and removal floor

the surface of all soft and flat out after dry stand-by, but not by fire or electric furnace preheating; semi rigid PVC plate with silk cotton dipped in acetone: gasoline (1:8) mixed solution degreasing dewaxing. Preheating and removal of wax plastic plate, should be placed in the room to be laid at least 24h,

in order to adapt to the paving environment. 14, on the cement base layer with plastic floor surface, its base surface should be smooth, hard, dry, smooth, clean, no grease and other impurities (including sand).

The finger board is made by splicing a plurality of wood boards. The upper and lower parts are no longer glued and clamped. Because the vertical boards use a saw-tooth-like interface, similar to the two fingers crossing and docking, they are called finger boards.
timber composite wall cladding architectural
complete thailand wood plastic composite
tongue and groove patio decks costs
problems with portico composite decking

Hors ligne

#2 24-03-2018 05:20:16

Tom Huntering

Re: Preheating and removal floor

This material is widely used nowadays. - Steven C Wyer

Pied de page des forums

Créez Votre Propre Forum
Insérer vos Graphiques
Dictionnaires de Traduction
Hébergé par ForumCrea.com